|
1.Start the engine and allow it to warm up until the temperature of the coolant reaches 80 °C to 90 °C.
|
|
2.Remove the engine oil filler cap.
|
|
3.
warning |
Use care as oil could be hot.
|
Remove the drain plug to drain oil.
|
|
4.Remove the under cover.
|
|
5.Use the special tool oil filter wrench (MH061590) to remove the engine oil filter. 6.Clean the filter bracket side mounting surface.
|
|
7.Apply a small amount of engine oil to the O-ring of the new oil filter. 8.Once the O-ring of the oil filter is touching the flange, use the special tool oil filter wrench (MH061590) to tighten to the specified torque. Tightening torque: Approximately 3/4 turn (22 ± 2 N·m) 9.Install the drain plug and refill the engine oil (Refer to ). 10.Race the engine 2-3 times, and check to be sure that no engine oil leaks from installation section of the oil filter.
|