|
1.Check engine oil quantity.
|
|
2.
caution |
Since sealant is applied to the thread of oil pressure switch, take care not to damage
the oil pressure switch when removing it.
|
Use the special tool Oil pressure switch wrench (MD998012) to remove the oil pressure
switch.
note |
Remove the terminal of oil pressure switch where the special tool Oil pressure switch
wrench (MD998012) is not fitted.
|
3. Install the oil pressure gauge.
note |
Use an adapter of PT 1/8 thread.
|
4.Run the engine to warm it. 5.After the engine has been warmed up, check that oil pressure is within the standard
value. Standard value:
At idle: 29 kPa or more At 3,500 r/min: 294 - 686 kPa
6.Remove the oil pressure gauge.
|
|
7.Apply the specified sealant to the thread of oil pressure switch. Specified sealant: 3M ATD Part No. 8660 or equivalent
|
|
caution |
Do not start the engine within one hour after the oil pressure switch has been installed.
|
8.Use the special tool Oil pressure switch wrench (MD998012) to tighten the oil pressure
switch to the specified torque. Tightening torque: 10 ± 2 N·m
|