|
- Using M.U.T.-III, perform CAN busline diagnosis.
|
|
Q.
Is the check result normal?
|
|
Correct CAN busline (Refer to GROUP 54C - Diagnosis - Can Bus
Diagnostic Chart ), and then go to Step 4 .
|
|
|
|
- Confirm whether the diagnosis codes are output from ASTC-ECU.
|
|
Q.
Is the diagnosis code output?
|
|
YES : Perform the troubleshooting of automatic transmission (Refer to GROUP 35B - Troubleshooting - Check
Chart for Diagnosis Code ).
|
|
|
|
- Reconfirm whether the diagnosis codes are output from engine-ECU
- Erase the diagnosis codes being output.
- Ignition switch: "LOCK" (OFF) to ON
- Confirm whether the diagnosis codes are output.
|
|
Q.
Is the diagnosis code output?
|
|
Intermittent malfunction in CAN busline between engine-ECU and ASTC-ECU (Refer
to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to
Cope with Intermittent Malfunction ).
|
|
|
|
- After replacing the ASTC-ECU, re-check the diagnosis code output.
|
|
Q.
Is the diagnosis code output?
|
|
Replace the engine-ECU. When the engine-ECU is replaced, write the chassis number
(Refer to GROUP 00 - How to Perform Chassis Number Writing ).
After replacing the engine-ECU, register the injector identification code and learn fuel injection (Refer
to GROUP 00 - Precautions Before Service - What The Common Rail Engine Learns ).
|
|
|