|
1.
warning |
When pressure testing the cooling system, slowly release cooling system pressure to avoid getting burned by hot coolant.
|
caution |
- Be sure to completely clean away any moisture from the places checked.
- When the tester is taken out, be careful not to spill any coolant.
- Be careful when installing and removing the tester and when testing not to deform the filler neck of the radiator.
|
Check that the coolant level is up to the filler neck. Install a radiator tester and apply 160 kPa pressure, and then check for leakage from the radiator hose or connections. 2.If there is leakage, repair or replace the appropriate part.
|