REMOVAL AND INSTALLATION


Pre-removal Operation
  • Engine Coolant Draining (Refer to ).
  • Air Cleaner Intake Duct Removal (Refer to GROUP 15 - Air Cleaner ).

 Post-installation Operation
  • Air Cleaner Intake Duct Installation (Refer to GROUP 15 - Air Cleaner ).
  • Engine Coolant Refilling (Refer to ).
  • A/T Fluid Supplying and Checking (Refer to GROUP 23A - On-vehicle Service, A/T Fluid Check ).




Removal steps


1.
 Drain plug


2.
 O-ring


3.
 Radiator cap
<<A>>
 >>A<<
 4.
 Radiator upper hose
<<A>>
 >>A<<
 5.
 Radiator lower hose


6.
 Cooler hose connection <A/T>


7.
 Hose <A/T>


8.
 Return hose connection <A/T>


9.
 Return pipe <A/T>


10.
 Feed hose clamp <A/T>


11.
 Radiator condenser tank hose


12.
 Cover


13.
 Cooling fan shroud


14.
 Radiator


15.
 Radiator support lower insulator


16.
 Radiator condenser tank


17.
 Air guide panel

REMOVAL SERVICE POINT

<<A>> RADIATOR UPPER HOSE/RADIATOR LOWER HOSE DISCONNECTION
Make mating marks on the radiator hose and the hose clamp. Disconnect the radiator hose.

INSTALLATION SERVICE POINT

>>A<< RADIATOR LOWER HOSE/RADIATOR UPPER HOSE CONNECTION
1.Insert radiator hose as far as the projection of the water pump inlet hose fitting, cooling water outlet hose fitting, thermostat case cover, cooling water outlet pipe or radiator.
2.Align the mating marks on the radiator hose and hose clamp, and then connect the radiator hose.