|
1.
caution |
Do not insert the screwdriver too deep as the stator
core could be damaged.
|
With a screwdriver blade inserted between the front bracket and stator core, pry to separate
the stator from the front bracket. 2.If they are hard to separate, lightly strike the bracket with a plastic hammer while
prying with the screwdriver.
|
|
caution |
Use care not to damage the rotor.
|
With the pulley side facing up, hold the rotor in a vice and remove the pulley.
|
|
1.Use a soldering iron (180 to 250 W) to unsolder the stator. This work should complete
within approximately four seconds to prevent heat from transferring to the diode. 2.When removing the rectifier from the regulator assembly, unsolder the points soldered
on the rectifier.
|
|
After installing the regulator assembly, insert a wire through the hole provided on the
rear bracket while pressing down on the brush, and secure the brush.
note |
By inserting a wire, the brush will be secured in place, and the installation of the rotor
will be easier.
|
|
|
After installing the rotor, remove the wire used to secure the brush.
|