|
1.Remove the lock nut from the shaft.
|
|
2.Hold the drive sprocket in a soft-jaw vice. 3.Shift the clutch sleeve to the drive sprocket side. 4.Use special tool Power steering lock nut special spanner (MB991013) to remove the
lock nut.
|
|
1.Use special tool Remover (MD998801) to support the ball bearing. 2.Use a press to push at a rear end of the rear output shaft, and then remove the radial
ball bearing.
note |
The bearing may fit loosely on the shaft, so that removal is possible without using
a press.
|
|
|
1.Place special tool Remover (MD998801) so that the load is applied at the bearing. 2.Use a press to push at the rear end of the rear output shaft, and then remove the
clutch hub and ball bearing.
note |
The clutch hub may fit loosely on the shaft, so that removal is possible without
using a press.
|
|
|
1.Fit the ball bearing and stopper plate onto the rear output shaft. 2.Use special tools to press in the ball bearing.
- Remover (MD998801)
- Installer cap (MD998812)
- Installer-100 (MD998813)
- Installer-200 (MD998814)
- Installer adapter (60) (MD998829)
|
|
1.Confirm the clutch hub installation direction, and fit onto the rear output shaft. 2.Use special tools press in the clutch hub.
- Remover (MD998801)
- Installer cap (MD998812)
- Installer-100 (MD998813)
- Installer-200 (MD998814)
- Installer adapter (44) (MD998821)
note |
The clutch hub may fit loosely on the shaft, so that installation is possible without
using a press.
|
|
|
Check that the clutch sleeve is in the correct direction for installation.
|
|
Use special tools to install the radial ball bearing.
- Remover (MD998801)
- Installer cap (MD998812)
- Installer-200 (MD998814)
- Installer adapter (44) (MD998821)
note |
The ball bearing may be fitted loosely on the shaft, so that installation is possible
without using a press
|
|
|
1.Hold the drive sprocket in a soft-jaws vice. 2.Shift the clutch sleeve to the drive sprocket side. 3.Using special tool Power steering lock nut special spanner (MB991013) tighten the
lock nut to the specified torque of 255 ± 10 N·m.
|
|
4.Stake the two places of the lock nut as shown in illustration.
|