|
1.
caution |
If replacing the transmission with a new one, if overhauling the existing transmission, or if the A/T fluid has deteriorated or is contaminated, the A/T fluid cooler line must always be flushed out.
|
Remove the hose shown in the illustration which allows the A/T fluid to flow from the A/T fluid cooler to the transmission. 2.
caution |
The engine should be stopped within one minute of it being started. If the A/T fluid has all been discharged before this, stop the engine at that point.
|
Start the engine and discharge the A/T fluid. Driving conditions: N range, idling Discharge amount: Approx. 3.5 L 3.
caution |
Stop pouring in the A/T fluid once 3.5 L has been poured in.
|
Pour in new A/T fluid through the oil filler tube. Amount to add: Approx. 3.5 L 4.Repeat the operation in step 2 and 3.
note |
Carry out steps 2 and 3 so that at least 8.0 L has been discharged from the cooler hose. After this, discharge a small quantity of A/T fluid and check for contamination. If the A/T fluid is contaminated, repeat steps 2 and 3.
|
5.Carry out the procedure in "A/T Fluid Change" from step 2 onwards.
|