|
1.Removal the A/T control relay.
|
|
2.Use the jumper leads to connect A/T control relay terminal 2 to the negative battery terminal and terminal 1 to the positive battery terminal. 3.Check the continuity between A/T control relay connector terminals 3 and 4 while alternately connecting and disconnecting the jumper leads from the battery terminals.
|
Jumper leads
|
Continuity between terminals 1 and 4
|
Connected
|
Continuity (Less than 2 Ω)
|
Disconnected
|
Open circuit
|
|
4.If there is a malfunction, replace the A/T control relay.
|