REMOVAL AND INSTALLATION


Pre-removal Operation
  • Engine Room Under Cover Removal
  • A/T Fluid Draining
    (Refer to .)
  • Propeller Shaft Removal
    (Refer to GROUP 25 .)

 Post-installation Operation
  • Propeller Shaft Installation
    (Refer to GROUP 25 .)
  • A/T Fluid Supplying
    (Refer to .)
  • Engine Room Under Cover Installation

<2WD>

REMOVAL STEPS


1.
 Transmission control cable connection


2.
 Cable bracket


3.
 Oil level gauge assembly
<<A>>
4.
 Starter assembly


5.
 Harness connector connection


6.
 A/T fluid cooler pipe connection


7.
 Bell housing cover


8.
 Drive plate connecting bolts


·
 Support the transmission with a transmission jack


9.
 No.2 crossmember assembly and transmission mount insulator assembly


10.
 Transmission assembly lower part coupling bolts


11.
 Front exhaust pipe bracket


12.
 Transmission assembly upper part coupling bolts

>>A<<
 13.
 Transmission assembly

<4WD>

REMOVAL STEPS


1.
 Transmission control cable connection


2.
 Cable bracket


3.
 Oil level gauge assembly
<<A>>
4.
 Starter assembly


5.
 Harness connector connection


6.
 A/T fluid cooler pipe connection


7.
 Bell housing cover


8.
 Drive plate connecting bolts


·
 Support the transmission with a transmission jack


9.
 No.2 crossmember assembly and transmission mount insulator assembly


10.
 Transmission assembly lower part coupling bolts


11.
 Front exhaust pipe bracket


12.
 Transmission assembly upper part coupling bolts

>>A<<
 13.
 Transmission assembly

REMOVAL SERVICE POINT

<<A>> STARTER MOTOR REMOVAL
Remove the starter assembly with the starter harness still connected, and secure it inside the engine compartment.

INSTALLATION SERVICE POINT

>>A<< TRANSMISSION ASSEMBLY INSTALLATION

Press the torque converter into the transmission properly, and then assembly into the engine.