DISASSEMBLY AND REASSEMBLY

		DISASSEMBLY STEPS
	1.	Parking sprag shaft
>>C<<	2.	Parking sprag spring
	3.	Parking sprag
>>B<<	4.	Sealing cap
	5.	Parking roller support shaft
	6.	Parking roller support
	7.	Dust seal guard
>>A<<	8.	Oil seal
	9.	Extension housing

ASSEMBLY SERVICE POINTS

>>A<<OIL SEAL INSTALLATION

1.Set special tools as shown in the illustration.

Installer adapter (MB990929)
Handle (MB990938)

>>B<<SEALING CAP INSTALLATION

1.Press into the dimensions shown in the illustration so that it is not slanted.
2.Apply the sealant as shown in the illustration.
Specified sealant:
3M™AAD part number 8672 or equivalent

>>C<<PARKING SPRAG SPRING INSTALLATION

Attach the end of the spring to the position shown in the illustration.