|
1.Set special tools as shown in the illustration so that they are pressed against the inner
race of the one-way clutch.
- Spring compressor (MB991630)
- Spring compressor retainer (MD998924)
2.Screw in the special tool nut, and lightly press against the inner race of the one-way
clutch. 3.Remove the snap ring.
|
|
1.Apply ATF to the D-ring.
|
|
2.Install the D-ring in the grooves on the outer and inner periphery of the piston.
Make sure that the D-ring is not twisted or damaged when installing.
|
|
Install the O-ring onto the center support at the position shown in the illustration.
|
|
1.Set special tools as shown in the illustration.
- Spring compressor (MB991630)
- Spring compressor retainer (MD998924)
2.Screw in the special tool nut, and lightly press against the inner race of the one-way
clutch. 3.Install the snap ring.
|