REASSEMBLY SERVICE POINTS |
>>A<< ONE-WAY CLUTCH INSTALLATION |
Install the one-way clutch so that the arrow stamp is oriented as shown in the illustration. |
>>B<< STOPPER PLATE INSTALLATION |
Install the stopper plate onto the low/reverse annulus gear. Make sure that the
stopper plate claw is securely engaged in the annulus gear groove. |
>>C<< THRUST BEARING #6 INSTALLATION |
|
Apply Vaseline or petroleum jelly on the thrust bearing #6, and then install
onto the output planetary carrier. |
>>D<< TTHRUST BEARING #5 INSTALLATION |
|
Apply Vaseline or petroleum jelly on the thrust bearing #5, and then install
on the overdrive planetary carrier. |