|
1.Park the vehicle on a flat, level surface.
|
|
2.Move the transmission control lever to the neutral position or the selector lever to the "N" position. Then place the transfer sift lever to the "2H" position <4WD>. Apply the parking brake. Raise the vehicle on a jack.
|
|
3.Turn the companion flange clockwise as far as it will go. Make the mating mark on the dust cover of the companion flange and on the differential carrier.
|
|
4.Turn the companion flange anti-clockwise as far as it will go, and measure the amount of distance the mating marks moved. Limit: 5 mm 5.If the backlash exceeds the limit value, remove the differential carrier assembly and check the following.
- Final drive gear backlash
- Differential gear backlash
|