REMOVAL AND INSTALLATION <M/T>

			Removal steps
<<A>>		·	Support the manual transmission assembly.
	>>A<<	1.	Transfer roll stopper
		2.	Transfer mount bracket
		3.	Transfer mount bracket assembly

REMOVAL SERVICE POINT

<<A>> SUPPORT THE MANUAL TRANSMISSION ASSEMBLY

Use a transmission jack to support the manual transmission assembly.

INSTALLATION SERVICE POINT

>>A<< TRANSFER ROLL STOPPER INSTALLATION

1.Tighten the transfer roll stopper provisionally.

2.Tighten the transfer roll stopper inner and outer so that the clearance (A) between them is as shown in the illustration.
3.Check that the clearance (B) between the stoppers are the same.

note

When new, a transfer roll stopper consists of one part, but will separate into outer and inner part during use.This is normal.