REMOVAL AND INSTALLATION


caution
  • *: Indicates parts which should be temporarily tightened, and then fully tightened with the vehicle on the earth in an unladen condition.
  • When the suspension is adjusted or replaced, the calibration of steering wheel sensor must be performed. (Refer to GROUP 35C, On-vehicle Service ). <Vehicles with ASTC>
Pre-removal Operation
  • Upper arm assembly (Refer to ).

 Post-installation Operation
  • Upper arm assembly (Refer to ).
  • Front wheel alignment check and adjustment (Refer to ).




Removal steps


1.
 Cap


2.
 Front wheel speed sensor harness clamp <Vehicles with ABS>


3.
 Shock absorber assembly