|
1.
caution |
- Install special tool arm set (MB991238) evenly, and so that the maximum length will be attained within the installation range.
- Do not use an impact wrench to tighten the bolt of special tool spring compressor body (MB991237), otherwise the special tool will break.
|
Use following special tools to compress the coil spring.
- Spring compressor body (MB991237)
- Arm set (MB991238)
|
|
2.
warning |
Do not use an impact wrench to remove the self-locking nut. Vibration of the impact wrench will cause special tools (MB991237 and MB991238) to slip and cause personal injury.
|
Use following special tools to secure the strut, and then remove the self-locking nut.
- Wrench (MB991681)
- Socket (MB992047)
|
|
1.
caution |
- Do not tighten the special tool bolt too tight. The tool will be broken if the bolt is tightened over the allowable torque 74 N·m.
- Install the special tools evenly, and so that the maximum length will be attained within the installation range.
- Do not use an impact wrench, as it will cause the bolt of the special tool to be seized.
|
Install the special tools same as its removal and compress the coil spring to install to the shock absorber.
- Spring compressor body (MB991237)
- Arm set (MB991238)
|
|
2.Align the coil spring lower end with the shock absorber spring seat stepped part.
|
|
install the spring bracket assembly which faces the shock absorber as shown in the illustration.
|
|
1.Tighten the self-locking nut loosely.
|
|
2.
caution |
Do not use an impact wrench, as it will cause the bolt of the special tool to be seized.
|
Install the special tools same as its removal and compress the coil spring to install to the shock absorber.
- Spring compressor body (MB991237)
- Arm set (MB991238)
|
|
3.Using following special tools tighten the self-locking nut 22 ± 2 N·m.
- Wrench (MB991681)
- Socket (MB992047)
|