STEERING WHEEL SENSOR CALIBRATION


caution If the work below is done, finally calibrate the steering wheel sensor. This is necessary because the ASTC-ECU should update the steering wheel sensor neutral point.

  • Front alignment adjustment
  • Steering wheel sensor removal and installation



  1. Park the vehicle on a level surface.
  2. caution Before connecting or disconnecting the M.U.T.-III, turn the ignition switch to the "LOCK" (OFF) position.
    Connect M.U.T.-III to the 16-pin diagnosis connector.
  3. Turn the ignition switch to the "ON" position.
  4. Select "Interactive Diagnosis".
  5. Select "Special function".
  6. Select "Steering angle sensor".
  7. Select "Calibration".
  8. Turn the ignition switch to the "LOCK" (OFF) position.
  9. Disconnect M.U.T.-III.