|
Check that the door glass operates smoothly and moves along the door glass runchannel
when the door window glass is fully raised and fully lowered. If there is a problem, adjust
by the following procedure.
|
|
1.Remove the door trim assembly (Refer to GROUP 52A, Door trim <Single
cab and Club cab>, <Double cab>).
|
|
2.Remove the waterproof film (Refer to <Single cab>, <Club
cab>, <Double cab>).
|
|
3.Remove the door window regulator assembly (Refer to <Single
cab>, <Club cab>, <Double
cab>).
|
|
4.Stretch the both bends ("A" shown in the figure) of channel guide on the door window regulator
assembly.
note |
The bend of "A" shown in the figure is used for positioning the door window regulator
assembly. However, stretching the A section enables the adjustment of door window glass. In
addition, keep the part "A" stretched.
|
5.Install the door window regulator assembly (Refer to <Single
cab>, <Club cab>, <Double
cab>).
|
|
6.Raise the door window glass and loosen the channel guide mounting bolts to adjust the
window glass slants appropriately.
|