Inspection Procedure A-4: The Timer Lock Function does not Work after the Doors have been Unlocked by the Keyless Entry System.

caution

Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.

COMMENT ON TROUBLE SYMPTOM

If the keyless entry timer lock does not work normally, the input signal circuit(s) to the keyless entry transmitter or the ETACS-ECU may be defective.

PROBABLE CAUSES

Malfunction of the keyless entry transmitter
Malfunction of the ETACS-ECU
Damaged harness wires and connectors

DIAGNOSIS PROCEDURE

STEP 1. Check the operation of the keyless entry system.

Check that the keyless entry system works normally.

Q. Is the check result normal?

	Go to Step 2.

	Refer to .

STEP 2. Check the customize function.

Using the customize function, check that the timer lock function time is set to any of the followings.

30s
60s
120s
180s

Q. Is the check result normal?

	Go to Step 3.

	Enable the keyless entry timer lock function by using the customize function (Refer to ).

STEP 3. Retest the system.

Check that the timer lock works normally.

Q. Is the check result normal?

	The trouble can be an intermittent malfunction (Refer to GROUP 00, How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).

	Replace the ETACS-ECU.