|
If the window glass automatically starts moving downwards at the wrong time while it is
being raised, carry out the following adjustment or replacement procedures.
|
|
1.Remove the cab rear end lower trim (Refer to GROUP 52A, Interior trim ).
|
|
2.Remove the waterproof film (Refer to ).
|
|
3.Remove the window regulator assembly from the rear slide window glass, and then raise
and lower the rear slide window glass by hand to check the operation force.
note |
Insert a cushion or similar object to prevent damage to the glass if it should happen
to fall down.
|
|
|
4.If the rear slide window glass does not move up and down smoothly, check or repair the
following points.
- Check the installation condition of the runchannel.
- Check the installation condition of the rear slide window sash
side and the rear slide window sash upper.
5.If repair or adjustment is not possible, replace the rear slide window sash side and
the rear slide window sash upper.
|