|
Check that the window glass operates smoothly and moves along the rear slide window glass
runchannel when the rear slide window glass is fully raised and fully lowered. If there is a problem,
adjust by the following procedure.
|
|
1.Remove the cab rear end lower trim (Refer to GROUP 52A, Interior trim ).
|
|
2.Remove the waterproof film and rear panel power window regulator assembly (Refer to ).
|
|
3.Stretch the both bends ("A" shown in the figure) of channel guide on the rear panel window
regulator assembly.
note |
The bend of "A" shown in the figure is used for positioning the rear panel window regulator
assembly. However, stretching the part "A" enables the adjustment of rear slide window glass.
In addition, keep the part "A" stretched.
|
4.Install the rear panel power window regulator assembly (Refer to ). 5.Activate the anti-trap function successively 3 times, and then deactivate the anti-trap
function.
|
|
6.Raise the rear slide window glass and loosen the channel guide mounting bolts to adjust
the window glass slants appropriately. 7.Set the anti-trap function (Refer to ).
|