|
Use a drill (Φ
4.0 mm) to make a hole in the rivet A and rivet B to break it,
and remove the rivet.
|
|
Use a rivet tool shown in the illustration to connect the parts with rivets by the following
procedures. 1.Insert rivet into the front bumper face and front bumper side reinforcement. 2.Place the rivet tool over portion C of rivet. 3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet
tool, press the handle of the tool. 4.Thin part of portion C of the rivet will cut off and the rivet is fixed in position.
|