REMOVAL AND INSTALLATION





1.
 Front three-diamond mark (Refer to <Single cab>, <Club and Double cab>.)

>>A<<
 2.
 Rear three-diamond mark

>>A<<
 3.
 L200 mark

>>A<<
 4.
 DI-D mark

INSTALLATION SERVICE POINT

>>A<< MARK INSTALLATION




1.Clean the mark installation surfaces on the body with unleaded petrol.
2.
caution When attaching the marks, the ambient temperature should be 20 - 38°C and the air should be completely free of dust. If the ambient temperature is lower than 20°C, the marks and the places on the vehicle body where the marks are to be attached should be heated to 20 - 30°C.
Peel off the protection sheet on the back of the mark to paste it on the installation position.