REMOVAL AND INSTALLATION

		Seat heater switch <Vehicles with heated seat> (Refer to Front Floor Console .)
	1.	Headrestraint
		Removal steps
	2.	Rear anchor cover <Club cab, Double cab>
	3.	Power seat harness connecter <Vehicles with power seat>
	4.	Seat belt switch connector
	5.	Heated seat harness connector <Vehicles with heated seat>
>>A<<	6.	Front seat assembly

INSTALLATION SERVICE POINT

>>A<< FRONT SEAT ASSEMBLY INSTALLATION

1.Confirm that the seat slide is locked. Then temporarily tighten all the nuts and bolts with no load applied to the front seat cushion.
2.Tighten all the nuts and bolts to the specified torque.
Tightening torque:
Bolt: 44 ± 10 N·m
Nut: 30 ± 5 N·m