|
caution |
Do not attempt to repair the wiring harness connectors of the SRS. If a defective wiring harness is found, repair or replace it by referring to the table below.
SRS-ECU terminal No.
|
Destination of harness
|
Remedy
|
1, 2
|
Instrument panel wiring harness → Front wiring harness → Front impact sensor (RH)
|
Correct or replace each wiring harness.
|
3, 4
|
Instrument panel wiring harness → Front wiring harness → Front impact sensor (LH)
|
Correct or replace each wiring harness.
|
8
|
Instrument panel wiring harness → SRS warning lamp
|
Correct or replace the Instrument panel wiring harness.
|
9, 10
|
Instrument panel wiring harness → Passenger’s air bag cut off switch → Passenger’s (front) air bag module
|
Correct or replace the instrument panel wiring harness.
|
11, 12
|
Instrument panel wiring harness → Clock spring → Driver’s air bag module
|
Correct or replace instrument panel wiring harness. Replace the clock spring.
|
13
|
Instrument panel wiring harness → Junction block (fuse No.21)
|
Correct or replace the instrument panel wiring harness.
|
16
|
Instrument panel wiring harness → Junction block (fuse No.15)
|
Correct or replace the instrument panel wiring harness.
|
18
|
Instrument panel wiring harness → Earth
|
Correct or replace the instrument panel wiring harness.
|
20
|
Instrument panel wiring harness → Diagnosis connector
|
Correct or replace the instrument panel wiring harness.
|
27, 28
|
Instrument panel wiring harness → Floor wiring harness → Seat belt pre-tensioner (passenger’s side)
|
Correct or replace each wiring harness.
|
29, 30
|
Instrument panel wiring harness → Floor wiring harness → Seat belt pre-tensioner (driver’s side)
|
Correct or replace each wiring harness.
|
|
|
|
danger |
After disconnecting the battery cable, wait 60 seconds or more before proceeding with the following work. In addition, insulate the negative battery terminal with a tape. The condenser inside the SRS-ECU is designed to retain enough voltage to deploy the air bag for a short time even after the battery has been disconnected, so serious injury may result from unintended air bag deployment if work is done on the SRS system immediately after the battery cables are disconnected.
|
caution |
The SRS components and seat belt with pre-tensioner should not be subjected to heat, so remove the SRS-ECU, driver’s and passenger’s (front) air bag modules, clock spring, front impact sensor, seat belt with pre-tensioner before drying or baking the vehicle after painting.
- SRS-ECU, air bag modules, clock spring and impact sensors: 93° C or more
- Seat belt with pre-tensioner: 90°C or more
|
caution |
Whenever you finish servicing the SRS, always erase the diagnosis code and check warning lamp operation to make sure that the system functions properly.
|
|
|
caution |
If checks are carried out by using the SRS-ECU harness connector, observe the following procedures: Insert the special tool extra fine probe (MB992006) into connector from harness side (rear side), and connect the tester to this probe. If any tool than special tool is used, damage to the harness and other components will result. Never insert the probe directly to the terminals from the front of the connector. The terminals are plated to increase their conductivity, so that if they are touched directly by the probe, the plating may break, which will cause drops in reliability.
|
|