Tool
|
No.
|
Name
|
Use
|
|
MB990784
|
Ornament remover
|
Removal of cover.
|
|
MB990803
|
Steering wheel puller
|
Steering wheel disconnection
|
|
MB991955
A: MB991824 B: MB991827 C: MB991910 D: MB991911 E: MB991825 F: MB991826
|
M.U.T.-III sub-assembly
A: Vehicle communication interface (V. C. I.) B: M.U.T.-III USB cable C: M.U.T.-III main harness A (Vehicles with CAN communication system) D: M.U.T.-III main harness B (Vehicles without CAN communication system) E: M.U.T.-III measure adapter F: M.U.T.-III trigger harness
|
Checking diagnosis code
caution |
For vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly.
|
|
|
MB991884
|
Resistor harness (For pre-tensioner)
|
Seat belt with pre-tensioner circuit check
|
|
MB991865
|
Dummy resistor
|
SRS air bag and seat belt with pre-tensioner circuit check
|
|
MB991866
|
Resistor harness
|
SRS air bag circuit check
|
|
MB686560
|
SRS air bag adapter harness
|
- Deployment of passenger’s (front) air bag module inside the vehicle
- Deployment of passenger’s (front) air bag module outside the vehicle
|
|
MB991885
|
Pre-tensioner adapter harness
|
- Deployment of seat belt with pre-tensioner inside the vehicle
- Deployment of seat belt with pre-tensioner outside the vehicle
|
|
MB991223
A: MB991219 B: MB991220 C: MB991221 D: MB991222
|
Harness set
A: Check harness B: LED harness C: LED harness adapter D: Probe
|
Continuity check and voltage measurement at harness wire or connector
A: For checking connector pin contact pressure B: For checking power supply circuit C: For checking power supply circuit D: For connecting a locally sourced tester
|
|
MB992006
|
Extra fine probe
|
Continuity check and voltage measurement at harness wire or connector
|