AIR BAG MODULE CHECK |
1.Check the pad cover for dents, cracks or deformation. 2.Check the connectors for damage, the terminals for deformation, and the harness for binds. 3.Check the air bag inflator case for dents, cracks or deformation. 4.Install the driver’s air bag module to the steering wheel and check fit and alignment with the wheel. 5.Install the passenger’s (front) air bag module to the instrument panel and front deck crossmember and check fit and alignment. |
CLOCK SPRING CHECK |
If any malfunction is found in the following inspections, replace the clock spring with a new one. 1.Check the connectors and protective tube for damage, and the terminals for deformation. 2.Visually check the case for damage. 3.Check to see that there is a charge (continuity) between the C-306 clock spring connector terminal 1 and C-304 horn switch. |
4.
5. As shown in the Figure, connect the circuit tester to the special tool extra fine probe (MB992006) and check to see that there is a charge between the terminals. |