|
- Power for the SRS warning lamp is supplied from the ignition switch (IG1).
- The SRS warning lamp illuminates when the ignition switch is turned to the "ON"
position and goes out after approximately 7 seconds if there is not a malfunction in the SRS
system.
|
|
This code will be set if the SRS warning lamp driving circuit is short or the transistor
failure in the SRS-ECU is detected.
|
|
- Damaged wiring harnesses of connectors
- Malfunction of the SRS-ECU
|
|
Check the SRS warning lamp drive circuit system. Refer to .
|