SERVICE SPECIFICATIONS

Item			Standard value	Limit
Headlamp aiming	Low beam (halogen headlamp)	Vertical direction	36 mm (0.69°) below horizontal (H)	Not within 21 mm (0.4°) below horizontal (H)
Headlamp aiming	Low beam (halogen headlamp)	Horizontal direction	15° sloping section intersects the vertical line (V)	± 26 mm (± 0.5°) from the vertical line (V)
Headlamp luminous intensity measurement cd (Corresponding to the illumination 40 m ahead of the vehicle at low beam)			-	30,000 cd or more per one headlamp

PRECAUTIONS ON HOW TO USE THE HEADLAMP ASSEMBLY

Be careful with the following items as resin lenses are used in the headlamp assembly.

Don’t illuminate the headlamp for three minutes or more when the headlamp is covered with scratch protector.
Don’t tape the outer lens.
Don’t scratch the outer lens surface with a sharp edged special tool.
Use the specified wax remover and rinse the wax off cleanly.
Use the specified genuine bulb.