|
|
1.Check that the current tyre inflation pressures meet the inflation pressure label.(Refer to GROUP 31 - On-vehicle Service  .)
|
|
|
2.Place the vehicle onto a speedometer tester.
|
|
3.Place wheel locks on front wheels.
| note |
Set the vehicle to 2WD.
|
|
|
4.For prevention of front wheel lateral runout, install extension fittings on front towing eye and tie down hook, and install both ends of anchor plate.
5.For prevention of vehicle from starting out, install chain or wire (the other end of which is tightly fixed on rear towing eye) on the vehicle.
6.Check that the speedometer indicating range is within the standard value or the needle fluctuation is within the limit.
Standard value <Speedometer to display km/h only>:
|
|
Speed km/h
|
20
|
40
|
80
|
120
|
160
|
Speedometer indicating tolerance km/h
|
20.0 - 24.0
|
40.0 - 44.0
|
80.5 - 85.5
|
121.5 - 127.5
|
162.5 - 169.5
|
|
Standard value <Speedometer to display MPH and km/h>:
|
|
Speed km/h (mph)
|
20 (10)
|
40 (25)
|
80 (50)
|
120 (75)
|
160 (100)
|
Speedometer indicating tolerance km/h (mph)
|
20.0 - 24.0 (10.0 - 12.5)
|
40.0 - 44.0 (25.0 - 27.0)
|
80.5 - 85.5 (50.3 - 53.5)
|
121.5 - 127.5 (76.0 - 80.0)
|
162.5 - 169.5 (101.5 - 106.0)
|
|
Limit: Needle fluctuation (Vehicle speed is 35 km/h or more) ± 3 km/h
|
)
)