|
Q.
Is the check result normal?
Go to Step 2.
Repair the defective connector.
|
|
Check the bulb of the lamp which does not illuminate.
|
|
Q.
Is the check result normal?
|
|
Replace the bulb of the lamp which does not illuminate.
|
|
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Check the resistance between the lamp connector and body earth.
- Resistance between F-04 rear combination lamp (tail: LH) connector terminal No.5 and body earth
- Resistance between F-02 rear combination lamp (tail: RH) connector terminal No.5 and body earth
OK: Continuity exists (2 Ω or less)
Q.
Is the check result normal?
Go to Step 5.
Go to Step 4.
|
|
note |
Prior to the wiring harness inspection, check intermediate connector F-07, and repair if necessary.
|
- Check the earth wires for open circuit.
Q.
Is the check result normal?
Go to Step 5.
Repair the wiring harness.
|
|
Q.
Is the check result normal?
Go to Step 6.
Repair the defective connector.
|
|
note |
Prior to the wiring harness inspection, check junction block connector C-221 <L.H. drive vehicles>, C-204 <R.H. drive vehicles>, intermediate connectors C-31 <R.H. drive vehicles> and F-07, and repair if necessary.
|
- Check the output lines for open circuit.
Q.
Is the check result normal?
Go to Step 7.
Repair the wiring harness.
|
|
Check that the tail/stop lamps illuminate normally.
|
|
Q.
Is the check result normal?
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
|
|
|
|
Replace the tail lamp socket.
|
|
|