|
(1)Turn the ignition switch to "ACC" position.
|
|
(2)Turn ON the radio and CD player power switch.
|
|
Q.
Is it possible to put the radio and CD player power in the "ON" position?
|
|
Q.
Is radio and CD player connector C-125 in good condition?
Go to Step 3.
Repair or replace the component(s). If the power switch is turned on, the radio
and CD player should operate normally.
|
|
(1)Disconnect radio and CD player connector C-125, and measure at the wiring harness
side. (2)Turn the ignition switch to "ACC" position.
|
|
(3)Measure the voltage between terminal 10 and earth. OK: System voltage
Q.
Is the check result normal?
Go to Step 5.
Go to Step 4.
|
|
note |
Prior to the wiring harness inspection, check joint connector C-127 and junction block
connectors C-207, C-208, and repair if necessary.
|
Q.
Are the wiring harnesses between radio and CD player connector C-125 (terminal 10)
and ignition switch (ACC) in good condition?
Go to Step 5.
Repair or replace the damage component(s). If the power switch is turned on, the
radio and CD player should operate normally.
|
|
Q.
Is the radio and CD player installed correctly?
|
|
Repair or replace the radio and CD player. If the power switch is turned on, the
radio and CD player should operate normally.
|
|
|
|
Install properly. If the power switch is turned on, the radio and CD player should
operate normally.
|
|
|