Inspection Procedure
12: There is Noise but No Reception for Both AM and FM or No Sound from AM, or No Sound from
FM.
DIAGNOSIS PROCEDURE
STEP 1. Check the state of the antenna.
Q.
Is the mast antenna assembled?
Go to Step 2.
Assemble the mast antenna. The radio should sound normally.
STEP 2. Check to see if inspections are taking place is an area exposed
to special electric fields.
Q.
Are inspections taking place under special electric field conditions (underground
garage, inside a building, etc).?
Go to Step 3.
Go to Step 4.
STEP 3. Relocate and check.
Automatically receive in a good reception area that is not exposed to special electric
fields.
Q.
Is reception of the strongest radio frequency possible within the area?
There is no action to be taken.
Go to Step 4.
STEP 4. Tune then check.
Q.
Did the sensitivity improve after tuning?
There is no action to be taken.
Go to Step 5.
STEP 5. Check the connection of the antenna plug and the radio and
CD player.
Q.
Is the antenna plug thoroughly connected to the radio and CD player?
Go to Step 6.
Thoroughly connect the antenna plug and the radio and CD player. The radio should sound
normally.
STEP 6. Check by replacing the radio and CD player.
Q.
Are operations normal when using another radio and tape player or CD player?
Either repair or replace the radio and CD player. The radio should sound normally.
Either repair or replace the antenna assembly. The radio should sound normally.