|
(1)Disconnect radio and CD player connector C-125.
|
|
(2)Measure the voltage between terminal number 11 and earth. OK: System voltage
Q.
Does the measured voltage correspond with this range?
When YES <radio and CD player does not execute memory save then.> : Either repair or replace the radio and CD player. Check that a memory is retained.
Go to Step 2.
|
|
Q.
Is radio and CD player connector C-125 in good condition?
Go to Step 3.
Repair or replace the damage component(s). Check that a memory is retained.
|
|
note |
Prior to the wiring harness inspection, check junction block connector C-209, C-213 and
joint connector C-132, and repair if necessary.
|
Q.
Are the wiring harness between radio and CD player connector C-125 (terminal 11) and
fusible link 20 (battery) in good condition?
Repair or replace the radio and CD player. Check that a memory is retained.
Repair or replace the damage component(s). Check that a memory is retained.
|