Inspection procedure B-1: Lamp Reminder Buzzer Function does not Work Normally.


caution Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.


COMMENTS ON TROUBLE SYMPTOM


The ETACS-ECU operates this function in accordance with the input signals below.

If this function does not work normally, these input signal circuit(s) or the ETACS-ECU may be defective.

PROBABLE CAUSES



DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III diagnosis code.


When the ignition switch is turned to the "LOCK" (OFF) position, check that the ETACS-ECU does not set the diagnosis code.

Q. Is the diagnosis code set?

Refer to diagnosis code chart .

Go to Step 2.

STEP 2. M.U.T.-III data list


Check the input signals below, which are related to the lamp reminder buzzer function.

Item No.
 Item name
 Normal condition
19
 Drive’s door switch
 ON
30
 Ignition switch(IG1)
 OFF
60
 Headlamp output
 Any of items is ON
59
 Tail lamp output
OK: Normal conditions are displayed for all the items.

Q. Is the check result normal?

YES <All the signals are received normally.> : Go to Step 3.

NO <The driver’s door switch signal is not received.> : Refer to inspection procedure C-5 "One of the door switch signals is not received ."

NO <The ignition switch (IG1) signal is not received.> : Refer to inspection procedure C-3 "The ignition switch (IG1) signal is not received ."

NO <The tail lamp or headlamp switch signal is not received.> : Refer to inspection procedure C-1 "The column switch (lighting and wiper switch) signal is not received ."

STEP 3. Retest the system.


The lamp reminder buzzer function should work normally.

Q. Is the check result normal?

The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).

Replace the ETACS-ECU.