|
Q.
Is the check result normal?
Go to Step 2.
Repair the defective connector.
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Resistance between C-108 RV meter connector terminal No.28 and body earth OK: Continuity exists (2 Ω or less)
Q.
Is the check result normal?
Go to Step 4.
Go to Step 3.
|
|
note |
Prior to the wiring harness inspection, check joint connector C-120 <R.H. drive vehicles> and repair if necessary.
|
- Check the earth wires for open circuit.
Q.
Is the check result normal?
Retest the system.
Repair the wiring harness.
|
|
(1)Disconnect the connector, and measure at the wiring harness side. (2)Ignition switch: LOCK (OFF) position
|
|
(3)Voltage between C-108 RV meter connector terminal No.26 and body earth OK: System voltage
Q.
Is the check result normal?
Go to Step 6.
Go to Step 5.
|
|
note |
Prior to the wiring harness inspection, check joint connector C-132 or junction block connector C-209 or C-213, and repair if necessary.
|
- Check the battery power supply open circuit.
Q.
Is the check result normal?
Retest the system.
Repair the wiring harness.
|
|
(1)Disconnect the connector, and measure at the wiring harness side. (2)Ignition switch: ON
|
|
(3)Voltage between C-108 RV meter connector terminal No.25 and body earth OK: System voltage
Q.
Is the check result normal?
Go to Step 8.
Go to Step 7.
|
|
note |
Prior to the wiring harness inspection, check joint connector C-127, junction block connector C-207 and C-208, and repair if necessary.
|
- Check the IG (ACC) power supply open circuit.
Q.
Is the check result normal?
Retest the system.
Repair the wiring harness.
|
|
Check that the RV meter correctly when the RV meter is replaced temporarily.
|
|
Q.
Is the check result normal?
|
|
Check that the RV meter correctly.
|
|
Q.
Is the check result normal?
|
|
The procedure is complete.
|
|
|