|
Q.
Is the abnormal voltage screen displayed immediately after the ignition switch is
turned to the ACC position?
|
|
There is no action to be taken.
|
|
|
|
Q.
Is the check result normal?
Go to Step 3.
Repair the defective connector.
|
|
(1)Disconnect the connector, and measure at the wiring harness side. (2)Ignition switch: LOCK (OFF) position
|
|
(3)Voltage between C-108 RV meter connector terminal No.26 and body earth OK: System voltage
Q.
Is the check result normal?
Go to Step 5.
Go to Step 4.
|
|
note |
Prior to the wiring harness inspection, check joint connector C-132 or junction block
connector C-209 and C-213, and repair if necessary.
|
- Check the battery power supply open circuit.
Q.
Is the check result normal?
Retest the system.
Repair the wiring harness.
|
|
Q.
Is a malfunction eliminated?
|
|
If no malfunctions are found in all steps, an intermittent malfunction is suspected.
Refer to GROUP 00,How to Use Troubleshooting/Inspection Service Points -
How
to Cope with Intermittent Malfunction .
|
|
|