|
caution |
The strand end of the twist wire should be within 10 cm from the connector. For details
refer to .
|
|
|
When checking the joint connector, ensure that its wiring harness side and its short pins
are not damaged.
Q.
Is the check result normal?
Go to Step 2.
Repair the defective connector. Replace the joint connector as necessary.
|
|
(1)Disconnect joint connector (CAN1) and the steering wheel sensor connector, and measure
at the wiring harness side. (2)Turn the ignition switch to the LOCK (OFF) position. (3)
caution |
When measuring the resistance, disconnect the negative battery
terminal. For details refer to .
|
Ensure that the negative battery terminal is disconnected.
|
|
(4)Continuity between C-119 joint connector (CAN1) terminal No.3 and C-308 steering wheel
sensor connector terminal No.3 OK: Continuity (2 Ω
or less)
|
|
(5)Continuity between C-119 joint connector (CAN1) terminal No.14 and C-308 steering wheel
sensor connector terminal No.4 OK: Continuity (2 Ω
or less)
caution |
Strictly observe the specified wiring harness repair procedure.
For details refer to .
|
Q.
Is the check result normal?
<All the resistances measure 2 Ω
or less>
Power supply
to the steering wheel sensor may be suspected. Diagnose the steering wheel sensor. Refer to .
NO : <Either or all of the voltages measure more than 2 Ω>
Repair
the wiring harness between joint connector (CAN1) and the steering wheel sensor connector.
|