|
This code is set when the mode selection damper control motor potentiometer does not send
any signal to the A/C-ECU due to short or open circuit.
|
|
- Malfunction of the mode selection damper control motor and potentiometer
- Damaged the wiring harness or connectors
- Malfunction of the automatic A/C control panel (A/C-ECU)
|
|
Q.
Is the check result normal?
Go to Step 2.
Repair the connector.
|
|
- Check the potentiometer power supply, earth and signal line for open or short
circuit.
Q.
Is the check result normal?
Go to Step 3.
Repair the wiring harness.
|
|
Q.
Is the check result normal?
|
|
Replace the mode selection damper control motor and potentiometer.
|
|
|
|
Q.
Is the diagnosis code set?
|
|
Replace the automatic A/C control panel (A/C-ECU).
|
|
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00, How to Cope
with Intermittent Malfunction )
|
|
|