REMOVAL AND INSTALLATION <SINGLE CAB>

Door window glass runchannel removal steps · Pull handle bracket (Refer to GROUP 52A, Door Trim .) >>B<< 1. Waterproof film 2. Door beltline weatherstrip inner 3. Door beltline moulding 4. Door window glass runchannel Door beltline weatherstrip inner removal steps · Door trim assembly (Refer to GROUP 52A, Door Trim .) 2. Door beltline weatherstrip inner Door beltline moulding removal steps · Door trim assembly (Refer to GROUP 52A, Door Trim .) 3. Door beltline moulding Rear lower sash removal steps · Pull handle bracket (Refer to GROUP 52A, Door Trim .) >>B<< 1. Waterproof film >>A<< 5. Rear lower sash Door opening weatherstrip inner removal steps · Cowl side trim, front scuff plate and rear pillar trim (Refer to GROUP 52A, Interior Trim .) 6. Door opening weatherstrip inner Door opening weatherstrip outer removal <<A>> 7. Door opening weatherstrip outer

Make a fabricated tool as shown in the illustration to remove the door opening weatherstrip outer.

caution When sticking the waterproof film, ensure that the sealant is applied under the inner panel water drain hole. Apply the specified sealant to the waterproof film as shown and stick the film. Specified sealant: 3M ATD Part No.8625 or equivalent