SERVICE SPECIFICATIONS

Item			Standard value	Limit
Headlamp aiming	Low beam (halogen headlamp)	Vertical direction	36 mm (0.69°) below horizontal line (H)	Between 21 mm (0.4°) to 51 mm (0.98°) downward from the horizontal line (H)
Headlamp aiming	Low beam (halogen headlamp)	Horizontal direction	Elbow point intersects the vertical line (V)	± 26 mm (± 0.5°) from the vertical line (V)
Headlamp luminous intensity measurement cd (When a screen is set 25 m ahead of the vehicle)			-	30,000 cd or more

PRECAUTIONS ON HOW TO USE THE HEADLAMP ASSEMBLY

Be careful with the following items as resin lenses are used in the headlamp assembly.

Don’t illuminate the headlamp for three minutes or more when the headlamp is covered with scratch protector.
Don’t tape the outer lens.
Don’t scratch the outer lens surface with a sharp edged special tool.
Use the specified genuine bulb.