REMOVAL AND INSTALLATION <5A/T>
Pre-removal Operation
Under Skid Plate and Engine Room Under Cover Removal (Refer to GROUP 51 - Under Cover
.)
A/T Fluid Draining (Refer to
.)
Transfer Oil Draining (Refer to
).
Front and Rear Propeller Shaft Removal (Refer to GROUP 25 - Propeller Shaft
.)
Front Exhaust Pipe and Front Exhaust Pipe Bracket Removal (Refer to GROUP 15 - Exhaust Pipe and Main Muffler
.)
Transmission Control Cable Connection Removal (Refer to
.)
Pipe Assembly Removal (Refer to
.)
Starter Assembly Removal (Refer to GROUP 16 - Starter Motor Assembly
.)
Transfer Control Lever Assembly Removal (Refer to
.)
No.2 Crossmember Assembly Removal (Refer to GROUP 32 - Rear Engine Mounting
.)
Post-installation Operation
No.2 Crossmember Assembly Installation (Refer to GROUP 32 - Rear Engine Mounting
.)
Transfer Control Lever Assembly Installation (Refer to
.)
Starter Assembly Installation (Refer to GROUP 16 - Starter Motor Assembly
.)
Pipe Assembly Installation (Refer to
.)
Transmission Control Cable Connection Installation (Refer to
.)
Front Exhaust Pipe and Front Exhaust Pipe Bracket Installation (Refer to GROUP 15 -Exhaust Pipe and Main Muffler
.)
Front and Rear Propeller Shaft Installation (Refer to GROUP 25 - Propeller Shaft
.)
Transfer Oil Supplying (Refer to
).
A/T Fluid Supplying (Refer to
.)
Under Skid Plate and Engine Room Under Cover Installation (Refer to GROUP 51 - Under Cover
.)
REMOVAL STEPS
1.
Oil level gauge assembly
2.
O-ring
3.
Harness connector connection
4.
A/T control harness connector connection
5.
Bell housing cover
6.
Dust seal guard
7.
Drive plate connecting bolts
8.
Transmission assembly lower part coupling bolts
·
Support the transmission with a transmission jack
9.
Transmission assembly upper part coupling bolts
>>A<<
10.
Transmission assembly
INSTALLATION SERVICE POINT
>>A<< TRANSMISSION ASSEMBLY INSTALLATION
Press the torque converter into the transmission properly, and then assembly into the engine.