|
caution |
The claw of the mirror is prone to breakage when working in cold temperatures. Always warm up the mirror claw and claw periphery to 20°C or higher before handling.
|
Slant the mirror upward with your hands. Then insert a flat-tipped screwdriver wrapped with protective tape between the pivot plate and mirror through the cut-out from behind the mirror. Now pry off the mirror claw and remove the mirror as shown.
|
|
1.Remove the mirror. 2.Release the claws of door mirror outer cover from the door mirror assembly as shown in the illustration.
note |
Because the claws A and B are not accessible, disengage the points C and D of the door mirror actuator and release the claws.
|
3.Remove the cover from the door mirror assembly.
|
|
Install the door mirror body assembly with the nuts in the numerical order as shown in the illustration.
|