Inspection Procedure
5: The screen is not normal in the navigation mode. (The own vehicle mark is dislocated.) <Except
vehicle for RUSSIA>
caution
Before replacing the multivision display, ensure that the
power supply circuit, the earth circuit, and the communication circuit are normal. (Check that
the voltage is 10 V or more.)
COMMENTS ON TROUBLE SYMPTOM
There is a failure in the wiring harness between the combination meter
and the multivision display, the GPS antenna, the respective connector(s), the vehicle speed
sensor or the multivision display.
PROBABLE CAUSES
Malfunctions of GPS antenna
Malfunctions of multivision display
Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. Confirmation in MMCS service mode
Check the items below in the MMCS service mode. (Refer to .)
Perform "Network/Connect Line
Check" in the MMCS service mode to check that the communication and wire connection with the
GPS are in good condition.
Perform "Vehicle Signal Check", and then check the status of the
vehicle speed signal.
Perform "Sensor Check", and then check the status of the vehicle
speed sensor and the gyro sensor.
Q.
Is the check result normal?
YES (OK for all) : Go to Step 6.
NO (GPS is not OK) : Go to Step 2.
NO (The vehicle speed sensor is not OK, or vehicle speed pulse does not increase after
starting from a standstill) : Go to Step 3.
NO (Gyro sensor is not OK) : Go to Step 6.
STEP 2. GPS reception check
(1)Start the multivision display.
(2)Press the [INFO] button.
(3)Select [Vehicle Position].
(4)Check if the GPS signals are received.
Q.
Is the check result normal?
Go to Step 6.
Perform Inspection Procedure "GPS signal cannot be received" (Refer to .),
and then go to Step 6.
STEP 3. Check the speedometer.
Check whether the speedometer works normally. (Refer to .)
Q.
Is the check result normal?
Go to Step 4.
Diagnose the combination meter. (Refer to Combination meter - Troubleshooting .)
STEP 5. Check the harness wire between D-127 joint connector terminal
No.17 and C-170 multivision display connector terminal No.13.
Check the communication lines for open circuit and short circuit.
Q.
Is the check result normal?
Go to Step 6.
Repair the wiring harness.
STEP 6. Check of the troubles
Drive the vehicle for some time with the GPS signals being received, and check if the
own vehicle mark is dislocated.
Q.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent
Malfunction ).