Since the trouble may still be present even the status is "Stored", set the vehicle to
the diagnosis code detection condition and check that the status changes to "Active". If the
status does not change from "Stored", carry out the following procedure. 1.Establish from the customer whether a fuse or connector has been replaced or disconnected. 2.If yes, erase the diagnosis code, and then check that no diagnostic code is reset.
If no diagnosis code is reset, the diagnosis is complete. 3.If no, follow the applicable Diagnosis Code Chart. Then check the wiring harness and
connector, and refer to "How to Cope with Intermittent Malfunction ."
