|
1.Before inspection, set the vehicle to the pre-inspection condition.
|
|
2.Turn the ignition switch to the "LOCK" (OFF) position and then connect the M.U.T.-III
to the diagnosis connector (Refer to GROUP 00 - Precautions Before Service - M.U.T.-III
Sub Assembly ).
|
|
3.Disconnect the ventilation hose from the positive crankcase ventilation (PCV) valve, and
then connect a vacuum gauge to the ventilation hose. Plug the PCV valve. 4.Start the engine and check that idle speed is approximately 650 r/min. 5.Check the inlet manifold vacuum. Limit: Minimum 60 kPa 6.Turn the ignition switch to the "LOCK" (OFF) position. 7.Remove the vacuum gauge and then connect the ventilation hose to the PCV valve. 8.Disconnect the M.U.T.-III.
|