|
1.Before inspection, set the vehicle to the pre-inspection condition.
|
|
2.Turn the ignition switch to the "LOCK" (OFF) position and then connect the M.U.T.-III
to the diagnosis connector (Refer to GROUP 00 - Precautions Before Service - M.U.T.-III
Sub Assembly ).
|
|
3.Set a timing light to the power supply line (terminal No. 3) of the ignition coil No.
1.
note |
The power supply line is looped and also longer than the other ones.
|
4.Start the engine and let it run at idle. 5.Check that ignition timing is at the standard value. Standard value: approximately 10° BTDC
note |
- The ignition timing may fluctuate within ±7°. This is normal.
- In higher altitude, the ignition timing is more advanced than the standard value
by approximately 5°.
- Wait till approximately 1 minute passes after the engine started, and check the
ignition timing when the engine stabilized.
|
6.Check the idle speed. Standard value: 650 ± 100 r/min
note |
- The idle speed is controlled automatically by the idle speed control system.
- When using the M.U.T.-III, select engine data list item No. 2 and take a reading
of the idle speed.
|
7.If the idle speed is outside the standard value, inspect the MPI system (Refer to
GROUP 13C - Troubleshooting - Inspection Chart for Trouble Symptoms ). 8.Remove the timing light. 9.Turn the ignition switch to "LOCK" (OFF) position and then disconnect the M.U.T-III.
|