|
1.Set the vehicle to the pre-inspection condition.
|
|
2.Turn the ignition switch to the "LOCK" (OFF) position and then connect the M.U.T.-III
to the diagnosis connector (Refer to GROUP 00 - Precautions Before Service - M.U.T.-III
Sub Assembly ). 3.Start the engine, and let it run at idle. 4.Check the idle speed. Select the item No. 2 of the Data List, Engine Revolution, and
take a reading of the idle speed. Standard value: 650 ± 50 r/min 5.If the idle speed is not within the standard value, inspect the diesel system (Refer
to GROUP 13D - Troubleshooting - Inspection Chart for Trouble Symptoms ).
|