Tool
|
Number
|
Name
|
Use
|
|
MB992080 a: MB992081 b: MB992082
|
Belt tension meter set a: Belt tension meter b: Microphone assembly
|
Alternator and others belt tension check
|
|
- MB992744
- MB992745
- MB992746
- MB992747
- MB992748
|
- Vehicle communication interface-Lite
(V.C.I.-Lite)
- V.C.I.-Lite main harness A (for vehicles with CAN communication)
- V.C.I.-Lite main harness B (for vehicles without CAN communication)
- V.C.I.-Lite USB cable short
- V.C.I.-Lite USB cable long
|
- Checking the ignition timing
- Checking the idle speed
|
|
MB991955
a: MB991824 b: MB991827 c: MB991910 d: MB991911 e: MB991825 f: MB991826
|
M.U.T.-III sub assembly
a: Vehicle communication interface (V. C. I.) b: M.U.T.-III USB cable c: M.U.T.-III main harness A (Vehicles with CAN communication system) d: M.U.T.-III main harness B (Vehicles without CAN communication system) e: M.U.T.-III adapter harness f: M.U.T.-III trigger harness
|
caution |
For vehicles with CAN communication,
use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness
B instead, the CAN communication does not function correctly.
|
- Checking the ignition timing
- Checking the idle speed
|
|
MB990767
|
Front hub and flange yoke holder
|
Holding the crankshaft pulley
|
|
MD998719
|
Pin
|
|
MB992103
|
Chain tension release bar
|
Camshaft and camshaft sprocket assembly (exhaust side) removal
|
|
MD998772
|
Valve spring compressor
|
Valve spring compression
|
|
MB992090
|
Retainer holder attachment
|
|
MB992089
|
Retainer holder C
|
|
MB992085
|
Valve stem seal pliers
|
Valve stem seal removal
|
|
MD998737
|
Valve stem seal installer
|
Valve stem seal press-fitting
|
|
MD998727
|
Oil pan FIPG cutter
|
Engine oil pan removal
|
|
MB991883
|
Flywheel stopper
|
Supporting the drive plate
|
|
MD998718
|
Crankshaft rear oil seal installer
|
Press-fitting the crankshaft rear oil seal
|
|
MB991448
|
Bush remover and installer base
|
Press-fitting the crankshaft front oil seal
|
|
MB991614
|
Angle gauge
|
Balancer shaft and oil pump module bolt installation
|
|
MB991454
|
Engine hanger balancer
|
Support of engine assembly
note |
- For the engine hanger balancer (MB991454), use a chain only.
- Engine hanger balancer (MB991454) is a part of the engine hanger assembly (MB991453).
|
|
|
MB991527
|
Hanger
|
|
MB991928
a: MB991929 b: MB991930 c: MB991931 d: MB991932 e: MB991933 f: MB991934
|
Engine hanger
a: Joint (50) × 2 b: Joint (90) × 2 c: Joint (140) × 2 d: Foot (standard) × 4 e: Foot (short) × 2 f: Chain and hook assembly
|
|
MB991895
|
Engine hanger
|
|
MB991956
|
Engine hanger plate
|
|
MB992853
|
Engine hanger plate
|